Page 1 of 1
Shuttle SN25P and LCD or VFD
Posted: Sat Jul 23, 2005 3:07 am
by kikistan
Hello
On the Shuttle SN25P there is a little space in front of the computer that could allow to have an LCD screen (as in XPC SB83G5M).
What kind of matrix could go in that space ??
Thank you for any idea
Posted: Mon Jul 25, 2005 9:53 am
by Tom
Hi kikistan,
Thank you for posting on the forum.
Aslong as you have room for one free 5.25" bay, you can fit any MX2/3/6 or the LK/VK/PK202-25 in a mount shown at
http://www.matrixorbital.com/index.php? ... s-mounting . If you have two spare 5.25" bays, you can fit a MX4/5 display or a LK/VK204-25 in a mount shown at the above link.
If you have anymore questions or concerns, please feel free to post.
Best Regards,
Posted: Tue Jul 26, 2005 2:55 am
by kikistan
OK
But in the SN25P there is a small space for an LCD screen (behind the plastic)
I just wanted to know what kind of matrix could be fit in that space.
TY
Posted: Tue Jul 26, 2005 9:36 am
by Henry
Hi,
THe problem is we do not have one of these cases here to see how big the space is, I would recommend you take a look at the LK202-24-USB and LK204-24-USB manuals and take a look at the end where there are drawings and use them to see if the display will fit.
Posted: Wed Jul 27, 2005 2:56 am
by kikistan
Apparently the case has a windows of 25 mm x 14 mm
That helps ?
Posted: Wed Jul 27, 2005 10:24 am
by Tom
kikistan,
That doesn't seem like the size of the space for the display because it is way too small for any of our units.
Have you looked at any of the displays you are interested in? What do you want in a display? All the measurements on the specification pages of each manual. All the manuals are found at
http://www.matrixorbital.ca/manuals/
Posted: Wed Aug 03, 2005 11:42 am
by listen01
hi,
i am also interested in one of these screens for my shuttle as well. do you have any displays that will fit into a 3.5" internal bay?
Posted: Wed Aug 03, 2005 12:59 pm
by Tom
Hi listen01,
You will be able to fit a 4x20 or smaller display in a 3.25" bay, but you will need to create your own mount. You can check any of the manuals at
http://www.matrixorbital.ca/manuals/ for the measurements at the specification section.
If you have anymore questions, please feel free to post.
Best Regards,
Posted: Fri Feb 24, 2006 2:07 am
by IsLNdbOi
Sorry for bumping up such an old thread, but this is what the original poster was talking about:
http://forums.sudhian.com/messageview.c ... sid=727019
go down to the very bottom of this page and see the post by "Radical_Monkey" with the detailed guide on how he modded his SN25P.