Tom,

We just found a discrepancy between the Index.htm manual for the glk240625 and the glk24064-25.pdf manual. The pdf discribes the Manual Override and shows where the actual over ride pins are. The htm manual shows the over ride as pins 5 & 6 of the Keypad pins (this doesn't work). Usine the ...

That doesn't work either. The LCD currently isn't mounted into our hardware and we may have had an ESD problem.

No, the jumper was removed with power only. After that an attempt to communicate at 19200 baud was made.

It appears that I'm no longer communicating at the same baud rate of the LCD Display. Using mogd.exe and LCD Tester, I've stepped through each baud rate, changed computers, performed the Manual Override using pins 5 & 6 of the keypad connector, changed RS-232 cable, without any luck. The display ...

Tom,

Thanks for the response. I can see how 2 static bargraphs can be presented, but I don't see how both of them can be dynamic (i.e., updating individual bars in each of the bargraphs). Can there be 2 individual bargraphs that can be updated?

Is it possible to have more than one bargraph at a time on the MLK24064-25? If not can the number of bars be increased beyond the 16 documented?

Looking at the GLK24064-25 Manual I do not see any mention for Cursor control (underline or blinking). Does the GLK24064-25 have cursor commands?