no i meant unscrewing the screws for the two plates so i can solder on the other side of the dsub because it was easyer to do that there. and so i did, now it work perfectly thx guys!

Okay, hmm, its very dificult to solder these.
is it possible to unscrew the screws and split the teo plates and sold on the other side?

now im here again, shall i solder thos things under de D-sub like pic 1 or pic 2?

thanx for the help!

Hope i will become as smart as you guys

Cheers!
/sebbe

Thanx that really helped!

Shall i change "RS-232 Speed and I2C settings"? or shall i leave it in the middle?

What baudrate shall i use? 192Somthingsomthing?

Okay, and where can i find thoes?
Edit: Oh i think i see them is it safe to solder them off? Im right sure i cant get them back if i take em off :O

Edit again: Or is it just umm metal? Not an component?

Sure. http://www.freeasphost.co.uk/ahx/bild7.jpg it may be impossible to read in the pic but it says: SIPEX SP232AEN 0243 http://www.freeasphost.co.uk/ahx/bild8.jpg http://www.freeasphost.co.uk/ahx/bild9.jpg http://www.freeasphost.co.uk/ahx/bild10.jpg The last image is the littel piece of paper that...

Sure, wait a minute. http://www.freeasphost.co.uk/ahx/bild1.jpg http://www.freeasphost.co.uk/ahx/bild2.jpg http://www.freeasphost.co.uk/ahx/bild3.jpg http://www.freeasphost.co.uk/ahx/bild4.jpg http://www.freeasphost.co.uk/ahx/bild5.jpg http://www.freeasphost.co.uk/ahx/bild6.jpg Is it enough? :)

i am using a LK204-25-WB

I tryed LCDC and when i run the quick startup guide it says that it dosent find the lcd :S but when i run lcdsmartie the funny text comes up So it is connected.

I have a little problem. i have bought a new datacable and i have made my homemade poweadapter an when i test the display for the first time it workd fine. The startlogo came up. When i then tried LCDsmartie this came upp (Picture). I have tried uProject but when i push for example Bar-graph the sam...