Hi tino, I tried following procedure but haven't succeeded yet. 1. switch off the device, put Jumper across J0 for override mode., 2. Switch on the LCD, with uproject open along with com port open and then remove the jumper. 3. upload the raw data, as showing in the picture attached by you. 4. Go in...

Thanks Tino, My problem right now is., previous programmer has given only the hex file, don't have the entire program. while fiddling with the start up screen using uproject, i guess, i messed up with the actual baudrate with which the LCD was communicating with the microcontroller, because after th...

Well., I'm in a fix now., What I tried next was to print some text which did work. but now there was some program which was running after the initialization (i.e. after 15secs) which has vanished, its all garbage now. I guess since I changed the baud rate that might be the issue., but now I don't kn...

Hi Tino, Thanks for your reply, I tired with what you had suggested, the message is also showing upload done. But then when I go into main menu and select the "Load startup screen" and press ok., its again showing all the garbage values. I'm not sure where exactly I'm missing the trick. pl...

Hi, I' trying to display characters on LCD 2041 Rev.2 board using u project software., but I'm continuously getting garbage characters on LCD. I tired the following: 1. Manual override by placing the jumper at J0, then set the baud rate at 19200 but still the problem continues. 2. I tired with Hyper...