Is there a specific page i can look at to see which one you mean? Or if you saw it in a magazine the name/month of the issue you saw it in would definitly help.

Not yet we've been rather busy getting some other stuff out the door.

Did you remove them as well from your CustomItems.Key1qq ?

Try removing the quotes from true and false , you returning strings now

What error does it give you?

Create a new custom item where you logic or the two?

Nope, nothing just yet but i've seen some movement in this area, nothing i can talk about sadly.

Drivers are available on our support site over here

How about an MOS-AL204B-YX its a 4x20 for only $49 and it has 4.84 mm x 9.22 mm characters the largest we offer without moving to the more expensive graphical units.

The paralax models are premodified to use TTL levels instead of the regular rs232 levels, this modification is possible on all models and usually involves either setting a physical jumper or bridging 2 pads with a small blob of solder or 0 Ohm resistor, the manual will explain how this is done for e...

I'm not sure what could cause that but lets try restoring the unit to factory defaults. Please put on the manual override jumper (See manual for details) and use mogd# to upload the attached filesystem image to the unit. Once uploaded it will be with a bit of luck be back to normal.

You have a gx that shipped with firmware rev 2.x from the factory, it doesn't accept upgrades meant for the 1.x model, nothing to worry about, the firmware you have is still the latest.

Just unplug the usb cable, plug it back in and it should be all good again.

The GX doesn't use the regular ftdi usb-> serial chips we use on many of our other products the speeds we where able to acchive using the usb-> serial chips where not up to par with the peformance we wanted. For writing your custom application we do supply a library you can use from any .Net languag...

I suggest you contact E-LAB Digital Engineering for support on their chip, we cannot help you with this.

If you can successfully communicate with the atmel from your pc you must leave the jumpers on rs232 mode and not ttl, I coudln't find a datasheet for your devkit so its really hard to validate for me. To get up and running i suggest communicating with your pc first and when thats up and running swit...