Display not found

GTT Designer Software Support

Moderator: Mods

Post Reply
bigmaple
LCD?
Posts: 8
Joined: Tue Apr 14, 2020 5:10 am
Location: Western Pennsylvania

Display not found

Post by bigmaple »

Hello,
I just purchased a eGTT50A-TPC-BLM-B0-H1-CS-V5. I have it connected via a Prolific USB to Serial COM Port, which enumerates as COM5.

I installed GTT Designer, 1.13.0.10242, along with GTT Support tool. The Support tool connects to the display fine. I can do rudimentary things with it like clear screen, draw lines, circles, & boxes... But, when I stop the Support tool, and run GTT Designer, pick GTT50A (no eGTT available), and try to "Detect Display", it just shows "No Display Found!".

If I proceed with a new project, it just shows "Connection: Disconnected" at the bottom, and I am not able to really do anything with the tool.

Any ideas what I should do next? Note that I am NOT trying to run GTT Designer and the Support Tool at the same time.

Henry
OMNIPRESENT
OMNIPRESENT
Posts: 3002
Joined: Tue Aug 14, 2001 6:00 pm
Contact:

Re: Display not found

Post by Henry »

The GTT Designer needs the display connected by the Mass Storage USB header.
Henry J.
President
Matrix Orbital

bigmaple
LCD?
Posts: 8
Joined: Tue Apr 14, 2020 5:10 am
Location: Western Pennsylvania

Re: Display not found

Post by bigmaple »

OK thanks, that did it. I must of missed that in the GTT Designer manual.

Post Reply