how to install Tempature Probs

pawn · Post by **pawn** » Mon Aug 09, 2004 4:35 pm

i got the dallas temp probs, and i got them hooked up to the display..

Whats the Best way to attach to probs.. I have 3 Water Cooling Blocks on my PC. I tried Taping but it dont hold, whats the best way to make them stick or hold without messing up the tempautre reading...

Pawn

Johnny · Post by **Johnny** » Tue Aug 10, 2004 5:26 am

I use a tiny drop of super glue. You can easily remove the sensor with a small watch screwdriver without any damage, at a later date. You can also use heat prove tape which is quite strong, only thing i can't see anywhere you would be able to buy it.

pawn · Post by **pawn** » Tue Aug 10, 2004 5:29 am

should i take a tiny drop of super glue on the flat part of the sensor or, put the sensor flat on the water block then place super glue over the top?

Johnny · Post by **Johnny** » Tue Aug 10, 2004 6:19 am

A pin head on the flat surface, and press this to a flat surface on your waterblock.

pawn · Post by **pawn** » Tue Aug 10, 2004 6:41 am

thanks man