Page 2 of 2
Posted: Fri Nov 11, 2005 9:05 pm
by ALEXA
Hi Tom
Everything going perfect with the LCD.
I still have the problem of no spare serial port to run it through.
Is there another port I can pick up the Data In and Data Out from.
Can I plug into any of the pins on the 25 pin parallel port or on the spare video display 15 pin port.
I can't add another serial port nor does a USB to Serial convertor work.
Posted: Sun Nov 13, 2005 6:56 pm
by ALEXA
HI Tom
Can't get my keypress to initiate the event
Although the keypad will enter the character in the test screen, I cant enter a keypad character in the events screen
Any suggestions?
Posted: Sun Nov 13, 2005 7:08 pm
by ALEXA
Hi Tom
I can't get my keypad to initiate the event
Any suggestions?
Posted: Mon Nov 14, 2005 11:15 am
by Tom
Hi Alexa,
Did you check which keys are being generated? Also you must make sure that the character you entered in the event editor is right. The keys are case sensitive too, so you have to make sure they are capital or not. Most likely the keys generated are in capital letters.
Posted: Mon Nov 14, 2005 2:22 pm
by ALEXA
Sorry Tom
Nowhere did it say on LCDC that you had to go out of screen builder and start display to have events activate
Posted: Mon Nov 14, 2005 4:16 pm
by Tom
Do your keys work after starting the display?
Posted: Mon Nov 14, 2005 9:29 pm
by ALEXA
Everything now AOK bar the virtual display intermittent
Posted: Tue Nov 15, 2005 9:24 am
by Tom
Excellent.
If you have anymore questions or concerns, please feel free to post them.
Best Regards,