Page 1 of 1
Keypad not working, MX4
Posted: Fri Jun 11, 2004 12:15 pm
by Enzo
Funny thing happened this AM - display started showing random characters and then hung. Re-booted system and all appears well except the keypad doesnot function. Anyone have similar problems and/or suggestions?
Thanks,
Enzo
Posted: Fri Jun 11, 2004 1:05 pm
by Miles
Hello...
Can you read the version type or module number of the display?
Posted: Fri Jun 11, 2004 1:31 pm
by Enzo
Hi Miles
The display shows:
Matrix Orbital
MX4 USB series
LCDC version is:
1.05.29
Is this what you mean?
Thanks,
Enzo
Posted: Fri Jun 11, 2004 3:17 pm
by Enzo
Miles, an update...
When I power up, the display shows random garbage. When I start LCDC, the display starts with the MO logo, and goes through the screens that are active. Still no keypad function, unless I go through "Virtual Screen."
I am able to advance a few screens with the on screen arrows, check E-mail, and then it, too, locks up. To get it back, I must stop the display and exit LCDC, then start it once again.
Enzo
Posted: Fri Jun 11, 2004 4:08 pm
by Miles
Can you email me at
myero@matrixorbital.ca and I'll send you a software program that will read the firmware version and module type of the display.
Posted: Fri Jun 11, 2004 6:04 pm
by Enzo
Hi Miles:
E-mail on the way.
Enzo
Posted: Mon Jun 14, 2004 10:45 am
by Miles
Thanks!! Please see your email!!