Page 1 of 1
Interesting Temp Sensor.. I think it will work...
Posted: Wed Jun 16, 2004 11:23 pm
by Eddiie
Came across these... Will they work? I got 4. The interesting thing is that it says they are calibrated for Farenheit (spelling?). ?
!
http://www.allelectronics.com/cgi-bin/c ... type=store
Did that link work?
Posted: Thu Jun 17, 2004 1:21 am
by Johnny
Yes, the link works but i dont think that probe will.
That sensor looks identicle to the Dallas 1-wire, but as far as I am aware, the only sensors detected in LCDC at the moment are the DS1820 and the DS18B20.
Posted: Thu Jun 17, 2004 1:22 am
by Mat-Moo
Don't think so, as they probbaly won't work with the dallas one wire protocol that is needed to talk to the probe.
Posted: Thu Jun 17, 2004 7:15 am
by Elliyanna
Eddiie,
Sorry these will not work.
These are thermal transistor not 1 wire devices.
The temp probes for the MX are Dallas 1 wire devices.
To try and clarify a 1 wire device is not a simple probe it is a complete device that communicates data over 1 wire.
To have a better understanding take a look at
http://www.ibutton.com (all of the devices listed there are 1 wire devices)
Hope this helps
Elliyanna
So Sad...
Posted: Sat Aug 07, 2004 11:20 am
by at_mosby
So Sad that I didn't do enough research before I purchased the inline temprature probes. Well, at least I found out the answer *before* adding water to the case!
Oh well, now I'll just have to build my own inline sensor set using Dallas 1 wire devices.