Matrix Orbital Corp

Dear forum,

i try to control some fans. This works fine but if i power up the computer.
First the fan starts spinning on a low speed. Than it stops.
If the usb-driver is loaded the startupscreen is displayed and the fan starts spinning
on full speed. (This is what i set with the Command Remember PWM [254 195 1 255]).

My questions. Is it posible to bring up the fan even if no usb driver is loaded.
so if the loading of the driver fails the fan will not run.

any idea ?

Dirk

Please see the following link regarding this question: http://www.lcdforums.com/forums/viewtopic.php?t=1653

Thanks - I am a litle confused.
I received some more displays (other colors for testing) - and they worked fine.
Ok your post say there is a new firmware - So i had a look on the versions.
The NOT running have the version 0x20 32(dec) and the fine one reports 0x21 33(dec).
Also the blinking cursor problem is in the version 32 - so i use the MemUploader Util i found
here in the forum - but this will not change the firmware - am i right on this ?
Or will it install a fixed version 32 ?

Is there a flashutil to change the fw ? We have received 20 more displays these days and this looks like they have also the bugy version 32 (didn't test them all yes) . Sending back newly ordered LCD's sounds bad.
In a few weeks we will order 200 Displays - would be a mess if we had to send them back also.

Thanks

Dirk

Sorry for any confusion and inconvenience regarding this matter. Please see your email on how we will resolve the problem.