Page 1 of 1
2nd line on Mx220 Disappearing
Posted: Sat Dec 25, 2004 2:12 pm
by Paintballislife
I can remember the exact number but its the beige color Mx 200 series witht he buttons 4 directional and 3 functions. Well ive had this for a month or so, and i just noticed the past few days the screen has been going wacko, its usually fixed by stop displaying, un plugging and plugging back in and starting again, any suggestions on what i can do? Sometime si can just stop the display and start it again and it works, also how do i get rid of an accidental LCDC (1), i cant seem to figure out how to stop it. Also the backlight seems to be shutting off, this is fixed by shutting it down and turning it back on.
Posted: Mon Dec 27, 2004 11:28 am
by Tom
You can try uninstalling and reinstalling the drivers for the display. You should even try removing it from the registry. The location of the registry entries can be found at
http://www.lcdforums.com/forums/viewtopic.php?t=1016.
To get rid of the LCDC(1) you must go to the task bar, right click on LCDC(1), and click on Exit LCDC.
Best Regards,
Posted: Mon Dec 27, 2004 1:21 pm
by Paintballislife
well i uninstalled lcdc, deleted the registry, how do i get rid of the drivers for the Mx? Its not showing up as a new thing, thus not being able to reinstall.
Posted: Tue Dec 28, 2004 5:16 pm
by Paintballislife
bump*
Posted: Wed Dec 29, 2004 8:57 am
by Tom
You can get rid of the drivers in the device manager by right clicking on the desired driver and selecting uninstall.
Posted: Wed Dec 29, 2004 9:13 am
by Paintballislife
ok well i got the device uninstalled, rebooted and such, PC sees it but LCDC wont... any suggestions? im trying autodetect but it wont see it.
Posted: Wed Dec 29, 2004 9:26 am
by Tom
Make sure the driver is working properly too. You can check it in the device manager. It should show the Matrix Orbital USB Broadcast driver or look similar to what the link at
http://www.lcdforums.com/forums/viewtopic.php?t=1032 has. LCDC won't detect it if the driver is not working properly.
Best Regards,
Posted: Wed Dec 29, 2004 9:30 am
by Paintballislife
ok yea sayin that the registry is incomplete. unintalled try again.
Edit* ok reinstall was a go, LCDC running now ill let it run and see what happens, thanks hope it works!
Posted: Wed Dec 29, 2004 9:46 am
by Tom
Your welcome....I hope it works for you too.
Best Regards,
Posted: Wed Dec 29, 2004 11:20 am
by Paintballislife
sigh* no it didnt work any time i like tap my case with ym foot it shuts off or move the case, i dont see any loose wires, any suggestions? i just got this not too long ago, is it still under waranty?
Posted: Wed Dec 29, 2004 11:46 am
by Tom
Are you using an internal or external USB cable?
Posted: Wed Dec 29, 2004 1:11 pm
by Paintballislife
im using an external, i just switched the ports to back USB and its working fine so far, i think the ones on the front are shot, ill be using an internal when i get the new case set up.