Page 1 of 1
GLK12232-25-SM installation help
Posted: Thu Feb 03, 2005 11:37 am
by pm1225
The device is connected to the serial port and it is getting the power from the PC via the floppy cable connector. The device powers up and the backlight stays on but I don't see anything else. I am unable to get anything displayed on it with the MOGD program.
Posted: Thu Feb 03, 2005 11:55 am
by Miles
Hello...
What type of cable are you using to connect to the com port from the module??
Posted: Thu Feb 03, 2005 11:56 am
by pm1225
Miles wrote:Hello...
What type of cable are you using to connect to the com port from the module??
The 4BR cable from Matrix Orbital.
Posted: Thu Feb 03, 2005 11:58 am
by Miles
Can you tell me what the orientation of the pins are according to color??
Posted: Thu Feb 03, 2005 12:05 pm
by pm1225
Miles wrote:Can you tell me what the orientation of the pins are according to color??
Actually its not the 4BR cable. Someone made the cable.
DISPLAY Computer
1 ---- +5VDC
2 ---- RX Display ---------------- 3 TX Comp
3 ---- TX Display ---------------- 2 RX Comp
4 ---- GND ----------------------- 5 GND
Posted: Thu Feb 03, 2005 2:19 pm
by Tom
When you power up the display, do you see a startup screen?