Page 1 of 1
Voltage Readings?
Posted: Fri Apr 08, 2005 1:16 pm
by McGreggor
I was just wonding if there is some sort of voltage reader that might work on 1wire interface to provide proper hardware based voltage readings of the motherboard? Much like you get with a volt meter?
Posted: Mon Apr 11, 2005 11:19 am
by Tom
Hi McGreggor,
Unfortunately, I have not come across a dallas 1-wire device that will read voltages. You may be able to check at
http://www.maxim-ic.com/pl_list.cfm/filter/21/ln/en .
Another alternative is to use motherboard monitor 5, if your motherboard is supported on the last version. Motherboard monitor can be found in the ecd that came with your display. You can also use Hmonitor, which can be found at
http://www.hmonitor.com/ . The both plugins are available on LCDC, and they can be downloaded at
http://www.lcdc.cc/downloads.htm .
If you have anymore questions or concerns, please feel free to contact me.
Best Regards,
