Page 1 of 1
Help pluggin mx2 internally???
Posted: Fri Oct 14, 2005 6:36 am
by equilibrium
Can anyone help me i want to connect the mx2 internally on my msi k8n diamond but wasnt sure on how could someone help please?
Thanks
DAve
Posted: Fri Oct 14, 2005 8:13 am
by Miles
Hi equilibrium,
Thank you for contacting Matrix Orbital forums. First off, do you have an internal USB cable like the one shown here:
http://www.matrixorbital.com/product_in ... munication
Posted: Fri Oct 14, 2005 12:46 pm
by equilibrium
Hi Miles thanks for replying yes i have a internal usb cable as shown.
Thanks Dave
Posted: Mon Oct 17, 2005 11:32 am
by Tom
Hi equilibrium,
Here is the following configuration.
+5V goes to Vcc(Pin1)
D- goes to Data0-(Pin 3)
D+ goes to Data0+(Pin 5)
Gnd goes to Ground(Pin 7)
D- might be shown as something else like P- on your board, but the configuration will be the same.
If you have anymore questions or concerns, please feel free to post them.
Best Regards,
Posted: Mon Oct 17, 2005 1:44 pm
by equilibrium
Tom wrote:Hi equilibrium,
Here is the following configuration.
+5V goes to Vcc(Pin1)
D- goes to Data0-(Pin 3)
D+ goes to Data0+(Pin 5)
Gnd goes to Ground(Pin 7)
D- might be shown as something else like P- on your board, but the configuration will be the same.
If you have anymore questions or concerns, please feel free to post them.
Best Regards,
Hi
Thanks for your reply i will give it a go and see if not ill get back to you. Thanks for your help
DAve