I dont mean to take over this topic, but i have the same screen. its the LK-204-25-V, PCB version 1.23. i would like to convert it to ttl levels for use with a microcontroller. i noticed that Raquel said that trance_nation's board was set at ttl levels so i think it can be done... any help would be apreciated...
thanks
What is wrong?
-
- LCD!
- Posts: 10
- Joined: Tue May 23, 2006 9:55 am
- Location: Sweden
-
- LCD!
- Posts: 10
- Joined: Tue May 23, 2006 9:55 am
- Location: Sweden
Hi
I guess you were talking about screwing/unscrewing the D-sub connector, sorry but you can't do that.
What I can suggest though is use small pieces of wire to bridge the gaps. Wire wrap wires work good for these kinds of reconnection of broken traces on the PCB.
I guess you were talking about screwing/unscrewing the D-sub connector, sorry but you can't do that.
What I can suggest though is use small pieces of wire to bridge the gaps. Wire wrap wires work good for these kinds of reconnection of broken traces on the PCB.
Raquel Malinis
Design and Development
Matrix Orbital
Design and Development
Matrix Orbital
-
- LCD!
- Posts: 10
- Joined: Tue May 23, 2006 9:55 am
- Location: Sweden