Page 1 of 1
GLK24064-25 Rev 1.3 setting buad rate
Posted: Fri Aug 04, 2006 10:06 pm
by fmshah
I recently purchased the GLK24064-25 Rev 1.3. It works just fine when I write to it at 19200 baud. I want to change the baud rate. None of the codes documented in the Rev 1.0 or Rev 1.2 manual seem to work.
The LCD did not come with a Rev 1.3 manual on the CD, and I cannot find a Rev 1.3 manual on your web site.
What are the baud rate speed values for the Rev 1.3 board.
Posted: Tue Aug 08, 2006 9:59 am
by Raquel
Hello fmshah.
Thank you for posting on the forum.
There is no release 1.3 of the GLK24064-25. The latest release is PCB Rev 2.0 and it should be printed on the board.
Is it possible for you to post a picture of your GLK24064-25?
Thanks.
image of GK24064-25 rev 1.3
Posted: Tue Aug 08, 2006 10:28 am
by fmshah
It turns out that my unit is a GK24064-25 and not a GLK24064-25. In any case, I don't see any documentation on your site for this unit.
photo of unit:
http://i98.photobucket.com/albums/l267/ ... ackbig.jpg
Posted: Tue Aug 08, 2006 10:48 am
by Raquel
Hi fmshah,
Sorry, it turns out (as you have shown) there is rev 1.3 (pardon me, this was before my time).
The manual for the rev 1.20 is the same for rev 1.30. Please check out the following link as to how to change the baud rate using uProject:
http://www.lcdforums.com/forums/viewtopic.php?t=3371
Use the parameters as stated in page 31 of the manual
http://www.matrixorbital.ca/manuals/GLK ... 25_120.pdf
Please let me know how it turns out.