Matrix Orbital Corp

Matrix Orbital Temperature Probe:


there is way to use Bitspower G 1/4in. Temperature Sensor Stop Fitting??

http://ep.yimg.com/ca/I/sidewindercompu ... 3_22151905

i want to install it into EK-Multioption RES 250 rev.2 Reservoirs

By the looks of it thats an analogue sensor the temperature probes on the MX are digital 1-wire sensors so thats not going to work.

Ray wrote:By the looks of it thats an analogue sensor the temperature probes on the MX are digital 1-wire sensors so thats not going to work.

so there is'nt anyway to know the water temp with the mx6?

Hi Pelo911,

If you're set on using your MX display and the Dallas One-Wire sensor for this project, you could attempt to waterproof the sensor with an epoxy and place it in your reservoir. This is not a standard application of the device and I would highly recommend doing extensive testing before placing it in your computer. Matrix Orbital of course cannot be responsible for any damage resulting from the set up.

~Troy

Or maybe with a DS2450 in combination with that probe but i'm guessing here, It'll take some custom hardware and possibly software to get it working for sure.