Matrix Orbital Corp

I attempted to move the jumpers from the rs232 square to the I2C square but made a mess of it, being inexperienced and having shaky hands.

There currently are no jumpers in any of the 5 squares.

What can I do to fix it? I want to run in I2C mode.

thanks
Phil M

Hi Phil,

The protocol resistors have a value of 0ohms; if you have removed them and all pads are intact you are in good shape. To bridge the connections for I2C, you can use a blob of solder on each of the two connections required, which should be easier than playing with those resistors.

Thanks,
Troy