Page 1 of 1
Posted: Fri May 10, 2002 9:07 pm
by mrmagoo_83
LCDC uses MBM5 to monitor temps thru the motherboards monitors. What do you do if you want to use more than whats on the motherboard? My MB has three temp sensors, but I want to use some probes in other places, so how do I get either LCDC or the LCD itself to monitor those temps, and display them. If this is confusing let me know and I will try to give more info.
Posted: Fri May 10, 2002 10:06 pm
by Stig
Hi.
You can check out this link
here for one way to do it.
Stig
Posted: Sun May 12, 2002 8:24 pm
by mrmagoo_83
Thanks, now you wouldn't know where to find a RPM monitoring circuit would ya?
Posted: Sun May 12, 2002 11:52 pm
by Stig
Nope. Sorry...
Stig
Posted: Mon May 13, 2002 8:48 am
by linear
This would be a good start.
<font size=-1>[ This Message was edited by: linear on 2002-05-13 08:49 ]</font>
Posted: Wed Jun 12, 2002 8:15 pm
by ReAX222
Matrix orbital Uses a basic Stamp, Don't they? What I'm wondering is, is there a way to program that stamp( with Basic maybe) to use the key pad interface and the Serial conection to gather temps and then use some kind of step up motor controller (run off the General outputs to control fan speeds?
Long story Short Is the stamp still a basic stamp, If not can it be connected to one or is it cheaper to buy just a stamp with an LCD?
Posted: Thu Jun 13, 2002 2:45 am
by Stig
They don't use a Stamp, they use a PIC and it's not reprogrammable.
Stig
Posted: Thu Jun 13, 2002 9:18 am
by Henry
Some of our newer units will be upgradeable... current they are not. A basic stamp uses a PIC bit all bunch of other stuff for easy development...