Page 1 of 1
Posted: Sun May 19, 2002 3:03 pm
by TSGrayson
My firend came over and hooked up my GLK12232-25. I was trying to figure it out after he hooked it up and I couldnt get it to work...I then tested the voltages and found out that he had it hooked up to +12V vice +5V for 5-6 hours...do you think it is fried? Hmph! Some friend!
Posted: Mon May 20, 2002 6:33 am
by TSGrayson
Just as an update it always only shows 3 stright dark lines across the LCD on 1,3, and 4.
Posted: Mon May 20, 2002 7:57 am
by Cammy
Sorry to say but she would be fried:(That model needs 5 volts only. Not what you wanted to hear I know:(
<font size=-1>[ This Message was edited by: Cammy on 2002-05-20 07:58 ]</font>
<font size=-1>[ This Message was edited by: Cammy on 2002-05-20 07:58 ]</font>
Posted: Mon May 20, 2002 9:52 am
by Cheese
What did your friend do exactly?
The 12232 uses a normal unmodified floppy cable (in all varieties I think), so you plug 12V in, it's just that the 12V pin aint connected to anything.
Saying this the 3 lines you describe sounds bad... very bad
r.
Posted: Mon May 20, 2002 10:52 am
by TSGrayson
Well, he ordered a matrix orbital from a distributor and soldered the connections...so basically, the one that said +5V had +12
Posted: Mon May 20, 2002 9:57 pm
by TSGrayson
Well guys, I tried everything I can think of...my LCD is now more...I think I will cremate it tomorrow
Now, how much is that VFD I always see?
Posted: Mon May 20, 2002 10:37 pm
by Henry
Posted: Tue May 21, 2002 5:44 am
by TSGrayson
Henry, just emailed ya!
Posted: Wed May 22, 2002 9:18 am
by TSGrayson
I just wanted to say that Matrix Orbital is one of the best companies that I ever had the privilege in buying from!
Posted: Thu May 23, 2002 2:57 am
by Cheese
On 2002-05-22 09:18, TSGrayson wrote:
I just wanted to say that Matrix Orbital is one of the best companies that I ever had the privilege in buying from!
Hehe it sure is
r.