MOGDsharp bug brightness setting
Posted: Wed Nov 20, 2013 1:04 pm
In Modgsharp v 1.15 the brightness setting should used FE 99 while changing the slider, then FE 98 to set and save the value. Instead it uses FE 99 while adjusting followed by FE 91 which sets and saves the contrast (at the brightness level). The contrast appears to set and save correctly after adjustments.
I could not find a place to report bugs in the software, so it there is a better place to report it (such as an email address or bug report form) it would be good to place that link on the software page.
I could not find a place to report bugs in the software, so it there is a better place to report it (such as an email address or bug report form) it would be good to place that link on the software page.