Hi All,
i used GLK24064-25-IU this with MOGD#1.1.8 after used wipe command i am not able use this device .Device was not detect & Error :Connot open comport
Regards,
Dilip
GLK24064-25-IU Not Detecting COM Port after wipe
-
- LCD?
- Posts: 4
- Joined: Fri Dec 07, 2018 4:20 am
-
- Matrix Orbital
- Posts: 247
- Joined: Thu Sep 24, 2015 9:38 am
Re: GLK24064-25-IU Not Detecting COM Port after wipe
Hi Dilip,
Welcome to the forums!
I understand that you have a GLK24064-25-1U display, and after using MOGD to wipe the display, you are not able to detect the display again.
Could you tell me what PCB Revision you have?
Also, did any errors occur while you were wiping the display?
Cheers,
Dan
Welcome to the forums!
I understand that you have a GLK24064-25-1U display, and after using MOGD to wipe the display, you are not able to detect the display again.
Could you tell me what PCB Revision you have?
Also, did any errors occur while you were wiping the display?
Cheers,
Dan
Daniel Divino
Technical Support
Matrix Orbital
Technical Support
Matrix Orbital
-
- LCD?
- Posts: 4
- Joined: Fri Dec 07, 2018 4:20 am
Re: GLK24064-25-IU Not Detecting COM Port after wipe
Hi Dan,
Thank you for reply.There no errors on wipe process & PCB revision Board 1.0.
Thank you for reply.There no errors on wipe process & PCB revision Board 1.0.
-
- Matrix Orbital
- Posts: 247
- Joined: Thu Sep 24, 2015 9:38 am
Re: GLK24064-25-IU Not Detecting COM Port after wipe
Hi Dilip,
Are you using a USB GLK24064R-25-1U display variant? Also, have you installed the proper USB drivers on the display?
Cheers,
Daniel
Are you using a USB GLK24064R-25-1U display variant? Also, have you installed the proper USB drivers on the display?
Cheers,
Daniel
Daniel Divino
Technical Support
Matrix Orbital
Technical Support
Matrix Orbital