GLK24064-25 Rev 1.3 setting buad rate

[fmshah]

I recently purchased the GLK24064-25 Rev 1.3. It works just fine when I write to it at 19200 baud. I want to change the baud rate. None of the codes documented in the Rev 1.0 or Rev 1.2 manual seem to work.

The LCD did not come with a Rev 1.3 manual on the CD, and I cannot find a Rev 1.3 manual on your web site.

What are the baud rate speed values for the Rev 1.3 board.

[Raquel]

Hello fmshah.

Thank you for posting on the forum.

There is no release 1.3 of the GLK24064-25. The latest release is PCB Rev 2.0 and it should be printed on the board.

Is it possible for you to post a picture of your GLK24064-25?

Thanks.

[fmshah]

It turns out that my unit is a GK24064-25 and not a GLK24064-25. In any case, I don't see any documentation on your site for this unit.

photo of unit: http://i98.photobucket.com/albums/l267/ ... ackbig.jpg

[Raquel]

Hi fmshah,

Sorry, it turns out (as you have shown) there is rev 1.3 (pardon me, this was before my time).

The manual for the rev 1.20 is the same for rev 1.30. Please check out the following link as to how to change the baud rate using uProject:
http://www.lcdforums.com/forums/viewtopic.php?t=3371

Use the parameters as stated in page 31 of the manual
http://www.matrixorbital.ca/manuals/GLK ... 25_120.pdf

Please let me know how it turns out.