4 wire USB connection

ALEXA · Post by **ALEXA** » Fri Nov 11, 2005 9:05 pm

Hi Tom

Everything going perfect with the LCD.

I still have the problem of no spare serial port to run it through.

Is there another port I can pick up the Data In and Data Out from.

Can I plug into any of the pins on the 25 pin parallel port or on the spare video display 15 pin port.

I can't add another serial port nor does a USB to Serial convertor work.

ALEXA · Post by **ALEXA** » Sun Nov 13, 2005 6:56 pm

HI Tom

Can't get my keypress to initiate the event

Although the keypad will enter the character in the test screen, I cant enter a keypad character in the events screen

Any suggestions?

ALEXA · Post by **ALEXA** » Sun Nov 13, 2005 7:08 pm

Hi Tom

I can't get my keypad to initiate the event

Any suggestions?

Tom · Post by **Tom** » Mon Nov 14, 2005 11:15 am

Hi Alexa,

Did you check which keys are being generated? Also you must make sure that the character you entered in the event editor is right. The keys are case sensitive too, so you have to make sure they are capital or not. Most likely the keys generated are in capital letters.

ALEXA · Post by **ALEXA** » Mon Nov 14, 2005 2:22 pm

Sorry Tom

Nowhere did it say on LCDC that you had to go out of screen builder and start display to have events activate

Tom · Post by **Tom** » Mon Nov 14, 2005 4:16 pm

Do your keys work after starting the display?

ALEXA · Post by **ALEXA** » Mon Nov 14, 2005 9:29 pm

Everything now AOK bar the virtual display intermittent

Tom · Post by **Tom** » Tue Nov 15, 2005 9:24 am

Excellent.

If you have anymore questions or concerns, please feel free to post them.

Best Regards,